With today's PCs is hot, you struggle to maintain the temperature in your case up to an acceptable level. Before spending money on a water cooling system, or start cutting extra fan connectors are some steps that take you that shaving can remove degrees. Taken individually, each represents only a small difference, but as a group that could save the system from overheating, and do it for a relatively low cost.
First, if the CPU is running hotControl of thermal gel that goes on top of the chip. This stuff increases the transfer of heat from the chip to heat sink. I opened the computer less than a year and has already found the gel on a thin white crust, completely useless for the transfer of dry heat.
Remove the chip and clean the old gel with article or agent of the sort. Install the processor. Then, when is the kind that has a contact surface of the center of the chip is a drop of gel on the surface.There should be no bigger than a large grain of rice.
If the chip is the type that uses the entire upper surface as a contact, you can make an X pattern from five points of the gel. Just make sure that the points are small! A bit 'of gel goes a long way.
So while you have the case open, blow all the dust. You can grow a white border along the edge of the fan blades of the CPU have seen. When the dust is bad, it is obviously something must be done. Even though it looks clean shot. Tinyparticles cling to the components, especially the chipset, keeping warm.
With compressed air or a fan of this super-sized onion. Do not use the small compressors just some hobbyists. In humid climates can water spray tiny droplets of condensation. (This is a type of water cooling is that you really do not want to!)
Finally, when the computer is? E 'sitting in direct sunlight, absorb heat? E 'in a small room, where openings mayblocked?
Keep your computer without hindrance from the sun, in a place where the air flow. This is the easiest step to take, and perhaps that is often overlooked.
No comments:
Post a Comment